ES-450SP 9-Pin Machine Controller Users Manual
10PLAY, FAST FORWARD and REWIND. Additionally, there is an EJECT button in the upper left hand corner of the front panel. Typically, pressing the S
11ES-450SP by the machine. The frame rate must be set for this function to operate properly. To set the frame rate, press SHIFT + EJECT. This sett
123. Switch to input monitor at the Mark In point 4. Revert to tape monitor at the Mark Out point 5. Stop the tape at the Mark Out point plus the
13Locate Functions The ES-450SP can store up to seven locate points internally. These locate points are stored as long as the unit is powered. The
14Note: The ES-450SP does not check for the validity of the entered timecode. It merely passes the entered timecode to the deck. This can cause un
15Technical Reference Electrical Interface The ES-450SP uses the EIA RS-422A protocol over a 9 pin D-Sub connector. The pinout is listed in the tabl
16Troubleshooting If for some reason the ES-450SP does not give you the expected results, take a moment to do some investigating. The most importan
17JLCooper Electronics Limited Factory Warranty JLCooper Electronics ("JLCooper") warrants this product to be free of defects in materials
2 ES-450, ES-450SP and ES-450SP are trademarks of JLCooper Electronics. All other brand names are the property o
3Table of Contents Description... 4 Setting up the ES-450SP...
4Description The ES-450SP is a self-contained machine controller for professional and semi-professional VTRs, audio decks and computer based editing
5Setting up the ES-450SP The ES-450SP can operate in either of two modes: as a stand-alone master controller for VTRs and decks that respond to the S
6Configuration Before using the ES-450SP, we recommend setting it up for the various ways you may need to use it in. Step Mode This setting is used t
7Track Arming Mode This determines how the audio track arming is handled. This is toggled by pressing SHIFT+R-PLAY. The options are: • Type 1 (D
8Timecode Select This set the timecode that the ES-450SP displays in its timecode window. This is toggled by pressing SHIFT+FFWD. The options are:
9Controls The ES-450SP was laid out in an ergonomic manner. It was designed to be used by left- or right-handed operators. With the operators hand r
Comments to this Manuals